Configuration/Image File Commands 129
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Configuration_Image.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
•
interface-name
—Specifies the outgoing interface name. The interface
name has the format:
vlan
{
integer
} |
ch
{
integer
} |
isatap{integer
} |
{
physical-port-name
}.The subparameter
integer
has the format: {
decimal-
digit
} | {
integer
}{
decimal-digit
}.
decimal-digit
has the range 0–9
If the egress interface is not specified, the default interface is selected.
Specifying interface zone=0 is equal to not defining an egress interface.
Understanding Invalid Combinations of Source and Destination
Some invalid combinations of source and destination exist. Specifically, if one
of the following conditions exists:
• The source file and destination file are the same file.
•
xmodem:
is the destination file. The source file can be copied to
image
,
boot
and
null:
only.
•
tftp://
is the source file and destination file on the same copy.
•
*.prv
files cannot be copied.
• The source or destination is a slave unit (except for image and boot files).
mirror-config cannot be used as a destination
The following table describes the copy characters:
Copying an Image File from a Server to Flash Memory
Use the copy
source-url
image command to copy an image file from a server
to flash memory.
Copying a Boot File from a Server to Flash Memory
Use the copy
source-url
boot command to copy a boot file from a server to
flash memory.
Copying a Configuration File from a Server to the Running Configuration
File
Character Description
! For network transfers, indicates that the copy process is taking place.
Each exclamation point indicates successful transfer of ten packets (512
bytes each).
. For network transfers, indicates that the copy process timed out.
Generally, several periods in a row means that the copy process may fail.s
To Next Page
Loading...
