Dell PowerConnect PC5524

334 Ethernet Configuration Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
• off —Disables Flow Control.
Default Configuration
Flow control is enabled.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
User Guidelines
Use the negotiation command to enable flow control auto.
Example
The following example enables Flow Control on port gi1/0/ 1
Console(config)# interface gigabitethernet 1/0/1
Console(config-if)# flowcontrol on
flowcontrol (Global)
Use the flowcontrol Global Configuration mode command to configure the Flow
Control global mode.
Syntax
flowcontrol {
receive-only | send-receive }
Parameters
• receive-only —The interfaces with enabled Flow Control will receive pause
frames, but will not send Flow Control pause frames.
•
send-receive —The interfaces with enabled Flow Control will receive and
send pause frames.
Default Configuration
receive-only.
Command Mode
Global Configuration mode