Dell PowerConnect PC5524

744 Quality of Service (QoS) Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\QoS.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
rate-limit (Ethernet)
Use the rate-limit Interface Configuration (Ethernet) mode command to
limit the incoming traffic rate on a port. Use the no form of this command to
disable the rate limit.
Syntax
rate-limit committed-rate-kbps [burst committed-burst-byte]
no rate-limit
Parameters
• rate —Specifies the maximum number of kilobits per second of ingress
traffic on a port. The range is 3–10000000.
•
burst bytes —The burst size in bytes (3000–19173960). If unspecified,
defaults to 128K.
Default Configuration
Rate limiting is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Example
The following example limits the incoming traffic rate on gigabitethernet
port
1/0/ 5 to 150,000 kbps.
Console(config)# interface gi1/0/ 5
Console(config-if)# rate-limit 150000
qos wrr-queue wrtd
Use the qos wrr-queue wrtd Global Configuration mode command to enable
Weighted Random Tail Drop (WRTD). Use the no form of this command to
disable WRTD.