Dell PowerConnect PC5524

Ethernet Configuration Commands 337
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
back-pressure
Use the back-pressure Interface Configuration (Ethernet) mode command to
enable back pressure on a specific interface. Use the no form of this
command to disable back pressure.
Syntax
back-pressure
no back-pressure
Default Configuration
Back pressure is enabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables back pressure on port gi1/0/ 5.
Console(config)# interface gigabitethernet 1/0/5
Console(config-if)# back-pressure
port jumbo-frame
Use the port jumbo-frame Global Configuration mode command to enable
jumbo frames on the device. Use the no form of this command to disable
jumbo frames.
Syntax
port jumbo-frame
no port jumbo-frame
Default Configuration
Jumbo frames are disabled on the device.