Dell PowerConnect PC5524

Spanning-Tree Commands 459
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Spanning-Tree.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
spanning-tree cost
Use the spanning-tree cost Interface Configuration (Ethernet, port-channel)
mode command to configure the spanning-tree path cost for a port. Use the
no form of this command to restore the default configuration.
Syntax
spanning-tree cost cost
no spanning-tree cost
Parameters
cost—Specifies the port path cost. (Range: 1–200000000)
Default Configuration
Default path cost is determined by port speed and path cost method (long or
short) as shown below:
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Example
The following example configures the spanning-tree cost on gigabitethernet
port
1/0/ 15 to 35000.
Console(config)# interface gigabitethernet 1/0/15
Console(config-if)# spanning-tree cost 35000
Interface Long Short
Port-channel 20,000 4
Gigabit Ethernet (1000
Mbps)
20,000 4
Fast Ethernet (100 Mbps) 200,000 19
Ethernet (10 Mbps) 2,000,000 100