Dell PowerConnect PC5524

500 VLAN Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\VLAN_ISCLI_Only.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Command Mode
Interface Configuration (Ethernet, port-channel) mode
switchport mode
Use the switchport mode Interface Configuration (Ethernet, port-channel)
mode command to configure the VLAN membership mode of a port. Use the
no form of this command to restore the default configuration.
Syntax
switchport mode { access | trunk | general | private-vlan {promiscuous |
host} | customer }
no switchport mode
Parameters
• access —Specifies an untagged layer 2 VLAN port.
•
trunk —Specifies a trunking layer 2 VLAN port.
•
general —Specifies a full 802-1q supported VLAN port.
•
customer —Specifies that the port is connected to customer equipment.
Used when the switch is in a provider network.
•
private-vlan promiscous —Private-VLAN promiscous port.
•
private-vlan host —Private-VLAN host port.
Default Configuration
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
• When the port mode is changed, it receives the configuration
corresponding to the mode.
• If the port mode is changed to access and the access VLAN does not exist,
then the port will not belongs to any VLAN.