Dell PowerConnect PC5524

sFlow Commands 419
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\750_sFlow.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
sflow counters-sampling
Use the sflow counters-sampling Interface Configuration mode command to
enable sFlow Counters sampling and to configure the maximum interval of a
specific port. Use the no form of this command to disable sFlow Counters
sampling.
Syntax
sflow counters-sampling interval receiver-index
no sflow counters-sampling
Parameters
 interval—Specifies the maximum number of seconds between successive
samples of the interface counters. (Range: 1, 15–86400.)
 receiver-index—Index of the receiver/collector. (Range: 1–8.)
Default
Disabled
Command Mode
Interface Configuration (Ethernet) mode
clear sflow statistics
Use the clear sFlow statistics EXEC mode command to clear sFlow statistics.
Syntax
clear sflow statistics [interface-id]
Parameters
interface-id—Specifies an interface ID. The interface ID must be an
Ethernet port.
Command Mode
EXEC mode