Dell PowerConnect PC5524

Tunnel Commands 647
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Tunnel.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
seconds—Specifies the time interval in seconds between DNS queries.
(Range: 10–3600)
Default Configuration
The default time interval between DNS queries is 10 seconds.
Command Mode
Global Configuration mode
User Guidelines
This command determines the time interval between DNS queries before the
ISATAP router IP address is known. If the IP address is known, the robustness
level that is set by the tunnel isatap robustness Global Configuration mode
command determines the refresh rate.
Example
The following example sets the time interval between DNS queries to 30
seconds.
Console(config)# tunnel isatap query-interval 30
tunnel isatap solicitation-interval
Use the tunnel isatap solicitation-interval Global Configuration mode
command to set the time interval between ISATAP router solicitation
messages. Use the no form of this command to restore the default
configuration.
Syntax
tunnel isatap solicitation-interval seconds
no tunnel isatap solicitation-interval
Parameters
seconds—Specifies the time interval in seconds between ISATAP router
solicitation messages. (Range: 10–3600)