Dell PowerConnect PC5524

Ethernet Configuration Commands 333
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
• capability —Specifies the capabilities to advertise. (Possible values: 10h,
10f, 100h,100f, 1000f). If unspecified, defaults to list of all the capabilities
of the port.
•
Preferred —Specifies the master-slave preference:
• Master—Advertise master preference
• Slave—Advertise slave preference
Default Configuration
Auto-negotiation is enabled and preferred default mode is master mode.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
Example
The following example enables auto-negotiation on gigabitethernet port
1/0/ 5.
Console(config)# interface gigabitethernet 1/0/5
Console(config-if)# negotiation
Console(config-if)#
flowcontrol
Use the flowcontrol Interface Configuration (Ethernet, Port-channel) mode
command to configure the Flow Control on a given interface. Use the no
form of this command to disable Flow Control.
Syntax
flowcontrol {auto | on | off}
no flowcontrol
Parameters
• aut —Specifies auto-negotiation.
•
on —Enables Flow Control.