Dell PowerConnect PC5524

510 VLAN Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\VLAN_ISCLI_Only.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Syntax
switchport general forbidden vlan {add vlan-list | remove vlan-list}
no switchport general forbidden vlan {add vlan-list | remove vlan-list}
Parameters
• add vlan-list —Specifies a list of VLAN IDs to add. Separate
nonconsecutive VLAN IDs with a comma and no spaces. Use a hyphen to
designate a range of IDs.
•
remove vlan-list —Specifies a list of VLAN IDs to remove. Separate
nonconsecutive VLAN IDs with a comma and no spaces. Use a hyphen
designate a range of IDs.
Default Configuration
All VLANs are allowed.
Command Mode
Interface Configuration (Ethernet, Port-channel) mode
Example
The following example forbids adding VLAN IDs 234 to 256 to
gigabitethernet port
1/0/ 7.
Console(config)# interface gigabitethernet 1/0/7
Console(config-if)# switchport mode general
Console(config-if)# switchport general forbidden vlan add 234-
256
map protocol protocols-group
Use the map protocol protocols-group VLAN Configuration mode command
to map a protocol to a group of protocols. Use the no form of this command
to delete a protocol from a group.
Syntax
map protocol protocol [ encapsulation ] protocols-group group
no map protocol protocol [ encapsulation ]