LLDP Commands 433
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\LLDP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
• ppvid—Adds/removes PPVID for advertising. PPVID 0 can be used to
advertise the PPVIDs capabilities of the interface.(Range: 0–4094)
• vlan—Adds/removse VLAN ID for advertising. (Range: 1–4094)
Default
No optional TLV is transmitted.
Command Mode
Interface Configuration (Ethernet) mode
lldp med enable
Use the lldp med enable Interface Configuration (Ethernet) mode command
to enable Link Layer Discovery Protocol (LLDP) Media Endpoint Discovery
(MED) on an interface. Use the no form of this command to disable LLDP
MED on an interface.
Syntax
lldp med enable [
tlv
…
tlv4
]
no lldp med enable
Parameters
tlv—Specifies the TLV that should be included. Available TLVs are: network-
policy, location, and poe-pse, inventory. The capabilities TLV is always
included if LLDP-MED is enabled.
Default Configuration
LLDP MED is disabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example enables LLDP MED with the location TLV on
gigabitethernet port
1/0/
3.
To Next Page
Loading...
