Dell PowerConnect PC5524

Address Table Commands 391
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
• filtering —Filters unregistered multicast packets.
Default Configuration
Unregistered multicast addresses are forwarded.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
Do not enable unregistered multicast filtering on ports that are connected to
routers, because the 224.0.0.x address range should not be filtered. Note that
routers do not necessarily send IGMP reports for the 224.0.0.x range.
You can execute the command before the VLAN is created.
Example
The following example specifies that unregistered multicast packets are
filtered on gigabitethernet port
1/0/1 :
Console(config)# interface gi1/0/1
Console(config-if)# bridge multicast unregistered filtering
bridge multicast forward-all
Use the bridge multicast forward-all Interface Configuration (VLAN) mode
command to enable forwarding all multicast packets for a range of ports or
port channels. Use the no form of this command to restore the default
configuration.
Syntax
bridge multicast forward-all {add | remove} {ethernet interface-list | port-
channel port-channel-list}
no bridge multicast forward-all
Parameters
• add —Forces forwarding of all multicast packets.
•
remove —Does not force forwarding of all multicast packets.