Dell PowerConnect PC5524

User Interface Commands 55
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\User_Interface.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Use the no exec-banner line configuration command to disable the EXEC
banner on a particular line or lines.
Example
The following example sets an EXEC banner that uses tokens. The percent
sign (%) is used as a delimiting character. Note that the $(token) syntax is
replaced by the corresponding configuration variable.
Device(config)# banner exec %
Enter TEXT message. End with the character '%'.
$(bold)Session activated.$(bold) Enter commands at the prompt.
%
When a user logs on to the system, the following output is displayed:
Session activated. Enter commands at the prompt.
banner login
Use the banner login command in Global Configuration mode to specify and
enable a message to be displayed before the username and password login
prompts. Use the no form of this command to delete the existing Login
banner.
Syntax
banner login d message-text d
no banner login
Parameters
• Delimiting character of your choice —A pound sign ( # ), for example. You
cannot use the delimiting character in the banner message.
$(location) Displays the system location string.
$(mac-
address)
Displays the base MAC address of the device.