Dell PowerConnect PC5524

Address Table Commands 405
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
show bridge multicast address-table static
Use the show bridge multicast address-table static EXEC mode command to
display the statically configured multicast addresses.
Syntax
show bridge multicast address-table static [vlan vlan-id] [address mac-
multicast-address | ipv4-multicast-address | ipv6-multicast-address] [source
ipv4-source-address | ipv6-source-address] [all | mac | ip
]
Parameters
• vlan vlan-id —Specifies the VLAN ID.
•
address {mac-multicast-address | ipv4-multicast-address | ipv6-
multicast-address}
—Specifies the multicast address. The possible values
are:
• mac-multicast-address—Specifies the MAC multicast address.
• ipv4-multicast-address—Specifies the IPv4 multicast address.
• ipv6-multicast-address—Specifies the IPv6 multicast address.
• source {ipv4-source-address | ipv6-source-address} —Specifies the source
address. The possible values are:
• i pv4-address—Specifies the source IPv4 address.
• ipv6-address—Specifies the source IPv6 address.
Default Configuration
When all/mac/ip is not specified, all entries (mac and ip) will be displayed.
Command Mode
EXEC mode
User Guidelines
A MAC address can be displayed in IP format only if it is within the range
0100.5e00.0000–- 0100.5e7f.ffff.