Dell PowerConnect PC5524

664 DHCP Server Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\DCHP_Server.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Parameters
ip-address—Specifies the IP address of a router. One IP address is required,
although up to eight addresses can be specified in one command line.
Command Mode
DHCP Pool Host Configuration mode
DHCP Pool Network Configuration mode
Default Configuration
No default router is defined.
User Guidelines
The router IP address should be on the same subnet as the client subnet.
Example
The following example specifies 10.12.1.99 as the default router IP address.
Console(config-dhcp)# default-router 10.12.1.99
dns-server
Use the dns-server DHCP Pool Configuration mode command to configure
the Domain Name System (DNS) IP servers available to a Dynamic Host
Configuration Protocol (DHCP) client. Use the no form of this command to
remove the DNS server list.
Syntax
dns-server ip-address [ ip-address2 ... ip-address8 ]
no dns-server
Parameters
ip-address—Specifies a DNS Server IP address. One IP address is required,
although up to eight addresses can be specified in one command line.
Command Mode
DHCP Pool Host Configuration mode