542 LACP Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\LACP.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
lacp port-priority
Use the lacp port-priority Interface Configuration (Ethernet) mode
command to set the physical port priority. Use the no form of this command
to restore the default configuration.
Syntax
lacp port-priority
value
no lacp port-priority
Parameters
value—Specifies the port priority. (Range: 1use the no form of this
command65535)
Default Configuration
The default port priority is 1.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets the priority of gigabitethernet port 1/0/6.
console(config)# interface
gi1/0/
6
console(config-if)# lacp port-priority 247
lacp timeout
Use the lacp timeout Interface Configuration (Ethernet) mode command to
assign an administrative LACP timeout to an interface. Use the no form of
this command to restore the default configuration.
Syntax
lacp timeout
{long | short}
no lacp timeout
To Next Page
Loading...
