Dell PowerConnect PC5524

Power over Ethernet (PoE) Commands 359
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\PoE.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
no power inline priority
Parameters
• critical —Specifies that the powered device operation is critical.
•
high —Specifies that the powered device operation is high priority.
•
low —Specifies that the powered device operation is low priority.
Default Configuration
The default configuration is set to low priority.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example sets the inline power management priority of
gigabitethernet port 4 to High.
Console(config)# interface gigabitethernet 1/0/4
Console(config-if)# power inline priority high
power inline usage-threshold
Use the power inline usage-threshold Global Configuration mode command
to configure the threshold for initiating inline power usage alarms. Use the no
form of this command to restore the default configuration.
Syntax
power inline usage-threshold percent
no power inline usage-threshold
Parameters
percent—Specifies the threshold in percent to compare to the measured
power. (Range: 1–99)