350 Ethernet Configuration Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
show storm-control
Use the show storm-control EXEC mode command to display the
configuration of storm control.
Syntax
show storm-control
[interface-id ]
Parameters
interface-id—Specifies the interface.
Command Mode
EXEC mode
Example
console#
show storm-control
Port State Rate [Kbits/Sec] Included
------ -------- --------------- ------------------------
gi1/0/
1 Enabled 12345 Broadcast, Multicast,
Unknown unicast
gi1/0/
2 Disabled 100000 Broadcast
User Guidelines
Use the storm-control broadcast enable Interface Configuration command to
enable storm control.
The calculated rate includes the 20 bytes of Ethernet framing overhead
(preamble+SFD+IPG).
If the suppression level in percentage is translated (for the current port’s
speed) to a rate that is lower then the minimum rate, the minimum rate
would be set.
Example
console(config)# interface gi1/0/1
console(config-if)#
storm-control broadcast level kbps
12345
To Next Page
Loading...
