Dell PowerConnect PC5524

648 Tunnel Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Tunnel.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Default Configuration
The default time interval between ISATAP router solicitation messages is 10
seconds.
Command Mode
Global Configuration mode
User Guidelines
This command determines the interval between router solicitation messages
when there is no active ISATAP router. If there is an active ISATAP router, the
robustness level set by the tunnel isatap robustness Global Configuration
mode command determines the refresh rate.
Example
The following example sets the time interval between ISATAP router
solicitation messages to 30 seconds.
Console(config)# tunnel isatap solicitation-interval 30
tunnel isatap robustness
Use the tunnel isatap robustness Global Configuration mode command to
configure the number of DNS query/router solicitation refresh messages that
the device sends. Use the no form of this command to restore the default
configuration.
Syntax
tunnel isatap robustness number
no tunnel isatap robustness
Parameters
number—Specifies the number of DNS query/router solicitation refresh
messages that the device sends. (Range: 1–20)
Default Configuration
The default number of DNS query/router solicitation refresh messages that
the device sends is 3.