Dell PowerConnect PC5524

Address Table Commands 399
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Address_Table.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Default Configuration
No addresses are defined.
Command Mode
Interface Configuration (Ethernet, port-channel) mode. It cannot be
configured for a range of interfaces (range context).
User Guidelines
This command enables adding secure MAC addresses to a routed port in port
security mode. The command is available when the port is a routed port and
in port security mode. The address is deleted if the port exits the security
mode or is not a routed port.
This command is required because the bridge address command cannot be
executed on internal VLANs.
Example
The following example adds the MAC-layer address 66:66:66:66:66:66 to
gigabitethernet port 1/0/1.
Console(config)# interface gigabitethernet 1/0/1
Console(config-if)# port security routed secure-address
66:66:66:66:66:66
show mac address-table
Use the show mac address-table EXEC command to view entries in the MAC
address table.
Syntax
show mac address-table [dynamic | static| secure] [vlan vlan] [interface
interface-id] [address mac-address]
Parameters
• dynamic —Displays only dynamic MAC address table entries.
•
static —Displays only static MAC address table entries.
•
secure —Displays only secure MAC address table entries.