Dell PowerConnect PC5524

348 Ethernet Configuration Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Ethernet.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Command Mode
Interface Configuration mode(Ethernet)
User Guidelines
•Use the storm-control broadcast level Interface Configuration command
to set the maximum rate.
•Use the
storm-control include-multicast Interface Configuration
command to also count multicast packets and optionally unknown unicast
packets in the storm control calculation.
•
Example
console(config)# interface gigabitethernet 1/0/1
console(config-if)#
storm-control broadcast enable
storm-control broadcast level kbps
Use the storm-control broadcast levelInterface Configuration mode
command to configure the maximum rate of broadcast. Use the no form of
this command to return to default.
Syntax
storm-control broadcast level kbps kbps
no storm-control broadcast level
Parameters
kbps—Maximum of kilo bits per second of broadcast traffic on a port.
(Range: GE: 3.5M–1G, 10GE: 8.5M–10G)
Default Configuration
1000
Command Mode
Interface Configuration mode (Ethernet)