Dell PowerConnect PC5524

138 Configuration/Image File Commands
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Configuration_Image.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Example
The following example renames the configuration file.
Console# rename configuration.bak m-config.bak
boot system
The boot system Privileged EXEC mode command specifies the active
system image file that is loaded by the device at startup.
Syntax
boot system { image-1 | image-2 } [switch number | all]
Parameters
• switch number— Specifies the unit number. If unspecified, defaults to the
master unit number.
•
image-1 —Specifies that image-1 is loaded as the system image during the
next device startup.
•
image-2 —Specifies that image-2 is loaded as the system image during the
next device startup.
Default Configuration
This command has no default configuration.
The default unit number is the master unit number.
Command Mode
Privileged EXEC mode
User Guidelines
Use the show bootvar command to determine which image is the active
image.