Dell PowerConnect PC5524

Spanning-Tree Commands 469
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\Spanning-Tree.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
no spanning-tree mst max-hops
Parameters
hop-count—Specifies the number of hops in an MST region before the
BDPU is discarded. (Range: 1–40)
Default Configuration
The default number of hops is 20.
Command Mode
Global Configuration mode
Example
The following example configures the maximum number of hops that a
packet travels in an MST region before it is discarded to 10.
Console(config)# spanning-tree mst max-hops 10
spanning-tree mst port-priority
Use the spanning-tree mst port-priority Interface Configuration (Ethernet,
port-channel) mode command to configure the priority of a port. Use the no
form of this command to restore the default configuration.
Syntax
spanning-tree mst instance-id port-priority priority
no spanning-tree mst instance-id port-priority
Parameters
• instance-id —Specifies the spanning tree instance ID. (Range: 1–15)
•
priority —Specifies the port priority. (Range: 0–240 in multiples of 16)
Default Configuration
The default port priority for IEEE Spanning Tree Protocol (STP) is 128.