Dell PowerConnect PC5524

Quality of Service (QoS) Commands 741
FILE LOCATION: C:\Users\gina\Desktop\Checkout_new\CLI Folders\Dell Contax
CLI\files\QoS.fm
DELL CONFIDENTIAL – PRELIMINARY 5/15/12 - FOR PROOF ONLY
Example
The followin 7 WRR queues.
Console(config)# wrr-queue bandwidth 6 6 6 6 6 6 6 6
priority-queue out num-of-queues
Use the priority-queue out num-of-queues Global Configuration mode
command to configure the number of expedite queues. Use the no form of
this command to restore the default configuration.
Syntax
priority-queue out num-of-queues number-of-queues
no priority-queue out num-of-queues
Parameters
number-of-queues—Specifies the number of expedite queues. Expedite
queues have higher indexes. (Range: 0–8). If number-of-queues = 0, all
queues are assured forwarding. If number-of-queues = 8, all queues are
expedited.
Default Configuration
All queues are expedite queues.
Command Mode
Global Configuration mode
User Guidelines
While configuring the priority-queue num-of-queues command, the
weighted round robin (WRR) weight ratios are affected because there are
fewer queues participating in WRR. This indicates that the corresponding
weight in the wrr-queue bandwidth Interface Configuration mode command
is ignored (not used in the ratio calculation).