Digi TransPort WR11 - Page 484

Configuring Virtual Private Networking (VPN) Configure Internet Protocol security (IPsec)
Digi TransPort® Routers User Guide
484
Configure advanced IPsec tunnel parameters
Command line
Command Instance Parameter Values Equivalent web parameter
eroute n mode tunnel,
transport
IPsec Mode.
eroute n ahauth off, md5, sha1 Use a AH authentication on this
tunnel.
eroute n ipcompalg off, deflate Use c compression on this tunnel.
eroute n oosdelsa on, off Delete SAs when this tunnel is
down.
eroute n ifvrrpmaster on, off Delete SAs when router is not a
VRRP master.
eroute n nosaoos on, off Go out of service if automatic
establishment fails.
eroute n nosadeactcnt Integer Go out of service after n
consecutive auto-negotiation
failures.
eroute n check_apnbu on, off This tunnel can only use apn.
eroute n apnbu 0=Main APN
1=Backup APN
This tunnel can only use apn.
eroute n ifent blank, ETH,
PPP
Link tunnel with interface with x,y.
x=Interface type
eroute n ifadd Integer Link tunnel with interface with x,y.
y=Interface number
eroute n inhibitno Comma-
separated list
of Integers
Inhibit this IPsec tunnel when
IPsec tunnels n are up.
eroute n requireno Integer Inhibit this IPsec tunnel unless
IPsec tunnel n is up.
eroute n usesecip on, off IKE negotiation source IP address
is taken from the Secondary IP
Address.
eroute n ipent blank, ETH,
PPP
IKE negotiation source IP address
is taken from the Interface x,y.
x=Interface type