Digi TransPort WR11 - Page 609

Configuring legacy protocols Configure TPAD parameters
Digi TransPort® Routers User Guide
609
Command Instance Parameter Values
Equivalent web
parameter
tpad n prefix_rem text (numeric) Remove prefix x from
number in ATD command.
tpad n suffix text (numeric) Use suffix x.
tpad n tl2deact 0-10000 On the main interface
Deactivate LAPB session x
seconds after TPAD X.25
call has been cleared.
tpad n baktl2deact 0-10000 On the backup interface
Deactivate LAPB session x
seconds after TPAD X.25
call has been cleared.
tpad n defpak 16,32,64,128,256,512,1024 Default X.25 Packet Size.
tpad n nua text Use NUA.
tpad n nui text Use NUI.
tpad n lcn 1-4095 LCN.
tpad n lcnup 1=up, 0=down LCN direction.
tpad n baknua text (Backup) Use NUA.
tpad n baknui numeric text (Backup) Use NUI.
tpad n baklcn 1-4095 (Backup) LCN.
tpad n baklcnup 1=up, 0=down (Backup) LCN direction
tpad n cingnua numeric text Report our NUA as n to
the X.25 network.
tpad n cud text Call User Data.
tpad n samecall 0 One per transaction.
tpad n samecall 1 Allow consecutive
transactions.
tpad n samecall 2 Allow concurrent
transactions.
tpad n delimchar 32-127 Use ASCII character x as
the delimiter character.
tpad n ftime 0-20000 Forward mode time x
milliseconds.
tpad n trig_str text Create an event when
reply from X.25 host
matches.