Digi TransPort WR11 - Page 610

Configuring legacy protocols Configure TPAD parameters
Digi TransPort® Routers User Guide
610
Command Instance Parameter Values
Equivalent web
parameter
tpad n IPaddr IP address Connect to remote IP
address.
tpad n iphdr 0=Off
1=On
2=8583 Ascii 4 byte
IP length header.
tpad n termid text Use Terminal ID (TID).
tpad n dotermid 1=enabled, 0=disabled Replace TID provided by
connected terminal with
configured TID.
tpad n tid text Use TID xxxxxxxxx with
incoming APACS 50
polling calls.
tpad n merchnum text Use merchant Number.
tpad n useconstr 1=enabled, 0=disabled Use Connect String.
tpad n constr text Use Connect String.
tpad n pollchars text The polling character set
is c.
tpad n domsgnb 1=enabled, 0=disabled Enable Message
Numbering
tpad n disdir 1=enabled, 0=disabled Disable Direct Mode.
tpad n bdir 1=enabled, 0=disabled Boot to Direct Mode.
tpad n uaarc 0-99 Use response code n in
unable to authorise
message.
tpad n clear_
dirtime
0-60000 Clearing time n
milliseconds.
tpad n trandel 0-5000 Delay transmitting the
APACS 30 string for x
milliseconds after
connecting to X.25 host.
tpad n teretran 1=enabled, 0=disabled Retransmit APACS 30
string if error detected.
tpad n delstx 1=enabled, 0=disabled STX/ETX removal.
tpad n no_enq 1=enabled, 0=disabled Do not transmit ENQ
characters.