Digi TransPort WR11 - Page 8

Digi TransPort® Routers User Guide
8
Configure rate adaptation 320
Configure command alias mappings 322
Configure protocol bindings 324
Configure virtual serial ports 326
Configure port redirection using RealPort 328
Configure sending serial data to multiple serial ports 332
Configure IPv6 addressing support 335
IPv6 support is for Ethernet interfaces only 335
IPv6 modes 335
Typical IPv6 configuration 335
IPv6 support in the web interface 337
IPv6 support in the command-line interface 339
Configure a WAN for IPv6 343
Configure a LAN for IPv6 344
Show and update the IPv6 source IP address policy table 347
Show DHCPv6 server status 348
Show DHCPv6 client status 349
Use DHCPv6 to learn IPv6 addresses 350
Use the Neighbor Discovery Protocol (NDP) cache 351
Delete a Neighbor Discovery Protocol (NDP) cache 352
Show the IPv6 routing table 353
Show IPv6 routing and address information 354
Show the IPv6 addresses assigned to an interface 355
Support for IPv6 packets in firewall rules 356
Configure PPP and external modems 357
Configure external modem support 358
Configure PPP mappings 360
Configure PPP parameters 364
Configure mobile PPP parameters 373
Configure advanced PPP parameters 374
Configure PPP negotiation 386
Configure PPP sub-configurations 393
Configure PPP over Ethernet 395
Configuring DHCP servers
About DHCP servers 397
Configure DHCP server for Ethernet interfaces 398
Configure advanced DHCP parameters 401
Configure advanced DHCP options 402
Configure DHCP options 404
Configure static lease reservations 406
Configuring network services
Configure network services 409
Configuring DNS
Configure DNS servers 415
DNS Server n parameters 415
DNS Server Update parameters 416
Configure Dynamic DNS (DynDNS) 420