Digi TransPort WR11 - Page 9

Digi TransPort® Routers User Guide
9
Dynamic DNS parameters 420
Advanced Dynamic DNS parameters 423
Configuring IP routing and forwarding
Supported routes 426
Dynamic routes 426
Static routes 426
Default routes 426
Routing modes 426
View the TransPort routing table 428
Configure route metrics 429
Configure IP routing parameters 430
Configure static routes 433
Advanced Static Route parameters 434
Related CLI commands 437
Configure default IP routes 441
Advanced Default route parameters 442
Configure Routing Information Protocol (RIP) settings 447
Configure global RIP Settings 447
Configure access lists 448
Configure authentication keys 449
Configure RIP advertisements 450
Configure Open Shortest Path First (OSPF) parameters 453
Configure Border Gateway Protocol (BGP) settings 456
Configure IP port forwarding and static NAT mappings 458
Configure multicast routes 460
Configure Virtual Routing and Forwarding (VRF) 462
VRF-Lite (Multi-VRF) 462
Information model objects (IMOs) 462
Virtual Routing Forwarding (VRF) entity 462
Equivalent routing entry 463
Virtual routing entry 463
Multi protocol BGP entity 464
Equivalent Cross Virtual Routing Entry 464
Cross virtual routing entry 465
Process for configuring VRFs 465
Support for Virtual Routing and Forwarding in the web and command-line interfaces 466
Configure VRF for Ethernet interfaces 467
Configure VRF for GRE tunnel interfaces 467
Configuring Virtual Private Networking (VPN)
Virtual Private Networks (VPNs) 469
Configure Internet Protocol security (IPsec) 470
About Internet Protocol Security (IPSec) 471
Configure IPsec tunnels 473
Configure IPsec tunnel default action 487
Configure IPsec groups 489
Configure Dead Peer Detection (DPD) 498
Configure Internet Key Exchange (IKE) 500
Configure IKEv2 511
Configure Layer 2 Tunneling Protocol (L2TP) 517
Use X.509 certificates with IPsec tunnels 522