Digi TransPort WR11 - Page 888

Managing networks and connections Analyze data traffic
Digi TransPort® Routers User Guide
888
tilde (~) symbol before the list of protocol numbers. For example, to only capture UDP traffic,
enter ~17 for this parameter.
IP Addresses
Filters out IP packets with particular source or destination IP addresses. The format of this
parameter is a comma-separated list of IP addresses. For example, you may want to exclude
the capture of traffic from IP hosts 10.1.2.3 and 10.2.2.2. To do this, enter 10.1.2.3,10.2.2.2
for this parameter. Conversely, to capture traffic to and from particular IP hosts only, use a
tilde (~) symbol before the list of IP addresses. For example, to only capture packets to and
from IP host 192.168.47.1, enter ~192.168.47.1 for this parameter.
3. Click Apply.
Command line
Command Instance Parameter Values Equivalent web parameter
ana 0 anon on, off Enable Analyser
ana 0 maxdata 16-2000 Maximum packet capture size
ana 0 logsize 3 -180 Log Size
ana 0 l1on on, off Protocol Layers / Layer 1
ana 0 l2on on, off Protocol Layers / Layer 2
ana 0 l3on on, off Protocol Layers / Layer 3
ana 0 xoton on, off Protocol Layers / XOT
ana 0 ikeon on, off Enable IKE debug
ana 0 qmion on, off Enable QMI trace
ana 0 snaipon on, off Enable SNAIP trace
ana 0 lapdon 0-7
See below
ISDN Sources
ana 0 lapbon 0-7
See below
LAPB Links
ana 0 asyon Bitmap
See below
Serial Interfaces
ana 0 syon Bitmap
See below
Raw SYNC Sources
ana 0 discardson on, off IP Options / Trace discarded packets
ana 0 loopon on, off IP Options / Trace loopback packets
ana 0 ipfilt Comma-separated
list
IP Packet Filters / TCP/UDP Ports