C
HAPTER
4
| Configuring the Switch
Configuring the Spanning Tree Algorithm
– 140 –
◆ Port Error Recovery Timeout – The time that has to pass before a
port in the error-disabled state can be enabled. (Range: 30-86400
seconds or 24 hours)
WEB INTERFACE
To configure global settings for STA:
1. Click Configuration, Spanning Tree, Bridge Settings.
2. Modify the required attributes.
3. Click Save.
Figure 40: STA Bridge Configuration
CONFIGURING
MULTIPLE SPANNING
TREES
Use the MSTI Mapping page to add VLAN groups to an MSTP instance
(MSTI), or to designate the name and revision of the VLAN-to-MSTI
mapping used on this switch.
CLI REFERENCES
◆ "STP Commands" on page 399
COMMAND USAGE
MSTP generates a unique spanning tree for each instance. This provides
multiple pathways across the network, thereby balancing the traffic load,
preventing wide-scale disruption when a bridge node in a single instance
To Next Page
