C
HAPTER
15
| Security Commands
Privilege Level Configuration
– 314 –
SRO – status/statistics read-only
SRW – status/statistics read-only
EXAMPLE
Security/Switch/Privilege/Level>configuration
Privilege Level Configuration:
==============================
Privilege Current Level: 15
Group Name Priviliege Level
CRO CRW SRO SRW
-------------------------------- --- --- --- ---
Aggregation 5 10 5 10
Debug 15 15 15 15
Diagnostics 5 10 5 10
IGMP_Snooping 5 10 5 10
IP 5 10 5 10
LACP 5 10 5 10
LLDP 5 10 5 10
LLDP-MED 5 10 5 10
MAC_Table 5 10 5 10
MLD_Snooping 5 10 5 10
MVR 5 10 5 10
Maintenance 15 15 15 15
Mirroring 5 10 5 10
Port_Security 5 10 5 10
Ports 5 10 1 10
Private_VLANs 5 10 5 10
QoS 5 10 5 10
SNMP 5 10 5 10
Security 5 10 5 10
Spanning_Tree 5 10 5 10
System 5 10 1 10
UPnP 5 10 5 10
VLANs 5 10 5 10
Voice_VLAN 5 10 5 10
Security/Switch/Privilege/Level>
security switch
privilege level group
This command sets the privilege level required for read or write access to
various software modules.
SYNTAX
security switch privilege level group group-name [cro] [crw] [sro]
[srw]
group-name - The name identifying a privilege group. (Options:
Aggregation, Debug, Diagnostics, IGMP_Snooping, IP, LACP, LLDP,
LLDP-MED, MAC_Table, MVR, Maintenance, Mirroring, Port_Security,
Ports, Private_VLANs, QoS, SNMP, Security, Spanning_Tree,
System, UPnP, VLANs, Voice_VLAN)
cro - Configuration read-only access. (Range: 1-15)
crw - Configuration read/write access. (Range: 1-15)
To Next Page
