C
HAPTER
15
| Security Commands
Management Access Commands
ā 322 ā
MANAGEMENT ACCESS COMMANDS
This section describes commands used to filter management access to the
switch through specified IP addresses.
security switch
access
configuration
This command displays the access mode and the number of authorized
addresses.
SYNTAX
security switch access configuration
EXAMPLE
Security/Switch/Access>configuration
Access Mgmt Configuration:
==========================
System Access Mode : Disabled
System Access number of entries: 1
W: WEB/HTTPS
S: SNMP
T: TELNET/SSH
Idx Start IP Address End IP Address W S T
--- ------------------------------- ------------------------------ - - -
1 192.168.0.4 192.168.0.4 N N Y
Security/Switch/Access>
Table 31: Management Access Commands
Command Function
security switch access
configuration
Displays the access mode and the number of authorized
addresses
security switch access
mode
Shows or sets the access mode
security switch access
add
Adds IPv4 addresses that are allowed management access
security switch access
ipv6 add
Adds IPv6 addresses that are allowed management access
security switch access
delete
Deletes an access management entry
security switch access
lookup
Displays specified access management entry
security switch access
clear
Clears all access management entries
security switch access
statistics
Displays or clears access management statistics
To Next Page
