Digisol DG-GS4528S - Stp Port Statistics; Stp Port Mcheck

C HAPTER 16 | STP Commands
– 414 –
stp port statistics This command displays STP statistics on protocol messages for any
specified ports and link aggregation groups.
SYNTAX
stp port statistics [port-list]
port-list - A specific port or range of ports. (Range: 1-28, or all)
EXAMPLE
This example displays STP statistics for port 1 and LAG1. For a description
of the items displayed in this example, refer to "Displaying Port Statistics
for STA" on page 231.
STP>port statistics 1
Port Rx MSTP Tx MSTP Rx RSTP Tx RSTP Rx STP Tx STP Rx TCN Tx TCN Rx Ill. Rx Unk.
--------- -------- -------- -------- -------- ------- ------- ------- ------- ------- -------
1 0 5122 7005 1899 0 0 0 0 0 0
STP>
stp port mcheck This command performs STP protocol migration check for specified ports.
SYNTAX
stp port mcheck [port-list]
port-list - A specific port or range of ports. (Range: 1-28, or all)
COMMAND USAGE
◆ This command re-checks the appropriate BPDU format to send on the
selected interface.
◆ If at any time the switch detects STP BPDUs, including Configuration or
Topology Change Notification BPDUs, it will automatically set the
selected interface to forced STP-compatible mode. However, you can
also use this command at any time to manually re-check the
appropriate BPDU format to send on the selected interfaces (i.e., RSTP
or STP-compatible).
EXAMPLE
STP>port mcheck
STP>