Digisol DG-GS4528S - Security Network Arp Inspection Mode; Security Network Arp Inspection Port Mode

C HAPTER 15 | Security Commands
ARP Inspection Commands
– 388 –
25 Disabled
26 Disabled
27 Disabled
28 Disabled
ARP Inspection Entry Table:
Type Port VLAN MAC Address IP Address
------- ---- ---- ----------------- -------------
Static 1 1 90-e6-ba-cb-cd-d7 192.168.0.9
Security/Network/ARP/Inspection>
security network arp
inspection mode
This command enables or disables Dynamic ARP Inspection globally on the
switch.
SYNTAX
security network arp inspection mode [enable | disable]
enable - Enables Dynamic ARP Inspection globally on the switch.
disable - Disables Dynamic ARP Inspection globally on the switch.
DEFAULT SETTING
Disabled
EXAMPLE
Security/Network/ARP/Inspection>mode enable
Security/Network/ARP/Inspection>
security network arp
inspection port
mode
This command enables or disables Dynamic ARP Inspection on a port or
range of ports.
SYNTAX
security network arp inspection port mode [port-list] [enable |
disable]
port-list - A specific port or a range of ports. (Range: 1-28 or all)
enable - Enables Dynamic ARP Inspection on a given port.
disable - Disables Dynamic ARP Inspection on a given port.
DEFAULT SETTING
Disabled
EXAMPLE
Security/Network/ARP/Inspection>port mode 1 enable
Security/Network/ARP/Inspection>