C
HAPTER
13
| VLAN Commands
– 304 –
EXAMPLE
VLAN>delete 2
VLAN>
vlan lookup This command displays port members for specified VLAN.
SYNTAX
vlan lookup [vlan-id]
vlan-id - VLAN identifier. (Range: 1-4095)
EXAMPLE
VLAN>lookup 2
VID Ports
---- -----
2 9
VLAN>
vlan status This command displays information about the VLAN attributes assigned to
a port.
SYNTAX
vlan status [port-list] [vlan-user]
port-list - A specific port or range of ports. (Range: 1-28, or all)
vlan-user – A software module that uses VLAN management
services to configure VLAN membership and VLAN port settings
such as the PVID or untagged VLAN ID. This switch supports the
following VLAN user modules:
combined: Shows information for all active user modules.
static: Ports statically assigned to a VLAN through the CLI, Web
or SNMP.
nas: Provides port-based authentication, which involves
communications between a Supplicant, Authenticator, and an
Authentication Server.
mvr: Eliminates the need to duplicate multicast traffic for
subscribers in each VLAN. Multicast traffic for all channels is sent
only on a single (multicast) VLAN.
voice_vlan: A VLAN configured specially for voice traffic
typically originating from IP phones.
mstp: The 802.1s Multiple Spanning Tree protocol uses VLANs
to create multiple spanning trees in a network, which
To Next Page
