C
HAPTER
13
| VLAN Commands
– 305 –
significantly improves network resource utilization while
maintaining a loop-free environment.
all: Shows information for all user modules.
conflicts: Shows information for all user modules where a
conflict exists.
DEFAULT SETTING
Display information about all ports and all user modules.
COMMAND USAGE
◆ The “conflicts” option shows information about a user module where a
conflict exists. When a software module requests to set VLAN
membership or VLAN port configuration, the following conflicts can
occur:
■
Functional conflicts between features.
■
Conflicts due to hardware limitations.
■
Direct conflicts between user modules.
◆ For a description of the information displayed by this command, see
"VLAN Port Status" on page 244.
EXAMPLE
VLAN>status 1 combined
Port Aware PVID Frame Type Ing Filter Tx Tag UVID Conflicts
---- -------- ---- ---------- ----------- ----------- ----- ---------
1 Enabled 1 All Enabled Untag This 1 No
VLAN>status 1 all
Port VLAN User Aware PVID Frame Type Ing Filter Tx Tag UVID Conflicts
---- ----------- -------- ---- ---------- ----------- ----------- ----- ---------
1 Static Disabled 1 All Disabled Untag This 1
NAS No
MVR Enabled No
Voice VLAN No
MSTP Enabled No
Combined Enabled 1 All Enabled Untag This 1 No
VLAN>
To Next Page
