Digisol DG-GS4528S - Security Switch Snmp Access Add; Security Switch Snmp Access Delete

C HAPTER 15 | Security Commands
SNMP Commands
– 346 –
security switch
snmp access add
This command adds or modifies an SNMPv3 access entry.
SYNTAX
security switch snmp access add group-name security-model
security-level [read-view-name] [write-view-name]
group-name - The name of the SNMP group. (Range: 1-32
characters, ASCII characters 33-126 only)
security-model - The user security model. (Options: any, v1, v2c, or
the User-based Security Model – usm)
security-level - The security level assigned to the group.
noAuthNoPriv - There is no authentication or encryption used
in SNMP communications.
AuthNoPriv - SNMP communications use authentication, but
the data is not encrypted.
AuthPriv - SNMP communications use both authentication and
encryption.
read-view-name - The configured view for read access.
(Range: 1-32 characters, ASCII characters 33-126 only)
write-view-name - The configured view for write access.
(Range: 1-32 characters, ASCII characters 33-126 only)
DEFAULT SETTING
Security model: any
Security level: noAuthNoPriv
COMMAND USAGE
Use this command to assign portions of the MIB tree to which each
SNMPv3 group is granted access. You can assign more than one view to a
group to specify access to different portions of the MIB tree.
EXAMPLE
Security/Switch/SNMP/Access>add r&d usm authpriv default_view ifEntry.a
Security/Switch/SNMP/Access>
security switch
snmp access delete
This command deletes an SNMPv3 access entry.
SYNTAX
security switch snmp access delete index
index - Index to SNMPv3 access table. (Range: 1-64)
DEFAULT SETTING
None