C
HAPTER
7
| Performing System Maintenance
Restoring Factory Defaults
– 252 –
RESTORING FACTORY DEFAULTS
Use the Factory Defaults page to restore the original factory settings. Note
that the LAN IP Address, Subnet Mask and Gateway IP Address will be
reset to their factory defaults.
CLI REFERENCES
◆ "system restore default" on page 268
WEB INTERFACE
To restore factory defaults:
1. Click Maintenance, Factory Defaults.
2. Click Yes.
The factory defaults are immediately restored, which means that no reboot
is necessary.
Figure 108: Factory Defaults
UPGRADING FIRMWARE
Use the Software Upload page to upgrade the switch’s system firmware by
specifying a software file provided for the switch.
CLI REFERENCES
◆ "Firmware Commands" on page 475
WEB INTERFACE
To upgrade firmware:
1. Click Maintenance, Software Upload.
2. Click the Browse button, and select the firmware file.
3. Click the Upload button to upgrade the switch’s firmware.
To Next Page
