C
HAPTER
15
| Security Commands
SNMP Commands
ā 326 ā
security switch
access statistics
This command displays or clears access management statistics.
SYNTAX
security switch access statistics [clear]
clear - Clears all access management statistics.
EXAMPLE
Security/Switch/Access>statistics
Access Management Statistics:
-----------------------------
HTTP Receive: 3 Allow: 0 Discard: 0
HTTPS Receive: 0 Allow: 0 Discard: 0
SNMP Receive: 0 Allow: 0 Discard: 0
TELNET Receive: 0 Allow: 0 Discard: 0
SSH Receive: 0 Allow: 0 Discard: 0
Security/Switch/Access>
SNMP COMMANDS
This section describes commands used to control access to this switch from
management stations using the Simple Network Management Protocol
(SNMP), including configuring community strings, trap managers, and
basic settings for SNMPv3.
SNMP Version 3 also provides strong security features that cover message
integrity, authentication, and encryption; as well as controlling user access
to specific areas of the MIB tree. To configure management access for
SNMPv3 clients, you need to first create a user, assign the user to a group,
create a view that defines the portions of MIB that the client can read or
write, and then create an access entry with the group and view.
Table 32: SNMP Commands
Command Function
security switch snmp
configuration
Displays the SNMP configuration settings
security switch snmp
mode
Displays or sets the SNMP administrative mode
security switch snmp
version
Displays or sets the SNMP protocol version
security switch snmp read
community
Displays or sets the community string for SNMP read access
security switch snmp
write community
Displays or sets the community string for SNMP read/write access
security switch snmp trap
mode
Displays or sets the SNMP trap mode
security switch snmp trap
version
Displays or sets the SNMP trap protocol version
To Next Page
