Digisol DG-GS4528S - Lldpmed Coordinates

C HAPTER 21 | LLDP-MED Commands
– 455 –
lldpmed coordinates This command shows or sets the LLDP-MED location for this device.
SYNTAX
lldpmed coordinates [latitude] [north | south] [coordinate-value]
lldpmed coordinates [longitude] [east | west] [coordinate-value]
lldpmed coordinates [altitude] [meters | floor] [coordinate-value]
latitude - Normalized to within 0-90 degrees with a maximum of 4
digits.
north - North of the equator.
south - South of the equator.
longitude - Normalized to within 0-180 degrees with a maximum
of 4 digits.
east - East of the prime meridian.
west - West of the prime meridian.
altitude - Normalized to within -32767 to 32767 with a maximum
of 4 digits.
meters - Representing meters of Altitude defined by the vertical
datum specified.
floor - Representing altitude in a form more relevant in buildings
which have different floor-to-floor dimensions. An altitude = 0.0 is
meaningful even outside a building, and represents ground level at
the given latitude and longitude. Inside a building, 0.0 represents
the floor level associated with ground level at the main entrance.
coordinate-value - The value assigned to the specified coordinate
parameter.
DEFAULT SETTING
None
EXAMPLE
LLDPMED>coordinates latitude north 24.49
LLDPMED>coordinates longitude east 120.59
LLDPMED>coordinates altitude meters 8
LLDPMED>coordinates
Location Coordinates : Latitude - 24.4900 North
Longitude - 120.5900 East
Altitude - 8.0000 meter(s)
Map datum - WGS84
LLDPMED>