C
HAPTER
15
| Security Commands
Management Access Commands
– 324 –
EXAMPLE
Security/Switch/Access>add 1 192.168.0.4 192.168.0.4 telnet
Security/Switch/Access>
security switch
access ipv6 add
This command adds IPv6 addresses that are allowed management access
to the switch through various protocols.
SYNTAX
security switch access ipv6 add access-id start-ip-addr end-ip-addr
[web | snmp | telnet]
access-id - Entry index. (Range: 1-16)
start-ip-addr - The starting IPv6 address of a range.
end-ip-addr - The ending IPv6 address of a range.
web - Adds IP address(es) to the HTTP/HTTPS group.
snmp - Adds IP address(es) to the SNMP group.
telnet - Adds IP address(es) to the Telnet/SSH group.
DEFAULT SETTING
None
COMMAND USAGE
◆ An IPv6 address must be formatted according to RFC 2373 “IPv6
Addressing Architecture,” using 8 colon-separated 16-bit hexadecimal
values. One double colon may be used to indicate the appropriate
number of zeros required to fill the undefined fields.
◆ To set a single address for a entry, enter the same address for both the
start and end of a range.
◆ If anyone tries to access a management interface on the switch from an
invalid address, the switch will reject the connection, enter an event
message in the system log, and send a trap message to the trap
manager.
◆ You cannot delete an individual address from a specified range. You
must delete the entire range, and reenter the addresses.
EXAMPLE
Security/Switch/Access>ipv6 add 1 2001:DB8:2222:7272::72
2001:DB8:2222:7272::72 web
Security/Switch/Access>
To Next Page
