Digisol DG-GS4528S - Displaying Log Messages; Figure 70: Displaying CPU Utilization

C HAPTER 5 | Monitoring the Switch
Displaying Basic Information About the System
– 199 –
Figure 70: Displaying CPU Utilization
DISPLAYING LOG
MESSAGES
Use the System Log Information page to scroll through the logged system
and event messages.
PARAMETERS
These parameters are displayed in the web interface:
Display Filter
◆ Level – Specifies the type of log messages to display.
■
Info – Informational messages only.
■
Warning – Warning conditions.
■
Error – Error conditions.
■
All – All levels.
◆ Start from ID – The error ID from which to start the display.
◆ with # entries per page – The number of entries to display per page.
Table Headings
◆ ID – Error ID.
◆ Level – Error level as described above.
◆ Time – The time of the system log entry.
◆ Message – The message text of the system log entry.
WEB INTERFACE
To display the system log:
1. Click Monitor, System, Log.
2. Specify the message level to display, the starting message ID, and the
number of messages to display per page.