Digisol DG-GS4528S - Stp Msti Map; Stp Msti Add

C HAPTER 16 | STP Commands
– 407 –
COMMAND USAGE
◆ Bridge priority is used in selecting the root device, root port, and
designated port. The device with the highest priority becomes the STA
root device. However, if all devices have the same priority, the device
with the lowest MAC address will then become the root device. Note
that lower numeric values indicate higher priority.
◆ The bridge priority plus the MSTI instance number, concatenated with
the 6-byte MAC address of the switch forms a Bridge Identifier.
EXAMPLE
STP>msti priority 240
STP>
stp msti map This command displays or clears the MSTI VLAN mapping configuration.
SYNTAX
stp msti map [msti] [clear]
msti - STP bridge instance number. (Range: 0-7, where 0 is the
CIST, and 1-7 are MST instances)
clear - Clears the VLANs map to the specified MST instance.
DEFAULT SETTING
None
EXAMPLE
STP>msti map
MSTI VLANs mapped to MSTI
---- --------------------
MSTI1 No VLANs mapped
MSTI2 No VLANs mapped
MSTI3 No VLANs mapped
MSTI4 No VLANs mapped
MSTI5 No VLANs mapped
MSTI6 No VLANs mapped
MSTI7 No VLANs mapped
STP>
stp msti add This command adds VLANs to an MST instance.
SYNTAX
stp msti add [msti] [vid]
msti - STP bridge instance number. (Range: 0-7, where 0 is the
CIST, and 1-7 are MST instances)
vid - VLAN identifier. (Range: 1-4095)