C
HAPTER
15
| Security Commands
SNMP Commands
– 343 –
COMMAND USAGE
◆ An SNMPv3 group sets the access policy for its assigned users,
restricting them to specific read and write views as defined by the
security switch snmp access add command (page 346). You can use the
pre-defined default groups, or create a new group and the views
authorized for that group.
◆ Note that the views assigned to a group must be specified with the
security switch snmp view add command (page 344).
EXAMPLE
Security/Switch/SNMP/Group>add usm steve tps
Security/Switch/SNMP/Group>
security switch
snmp group delete
This command deletes an SNMPv3 group entry.
SYNTAX
security switch snmp group delete index
index - Index to SNMPv3 group table. (Range: 1-64)
DEFAULT SETTING
None
EXAMPLE
Security/Switch/SNMP/Group>lookup
Idx Model Security Name Group Name
--- ----- -------------------------------- -----------------------------
1 v1 public default_ro_group
2 v1 private default_rw_group
3 v2c public default_ro_group
4 v2c private default_rw_group
5 usm default_user default_rw_group
6 usm steve tps
Number of entries: 6
Security/Switch/SNMP/Group>delete 6
Security/Switch/SNMP/Group>
security switch
snmp group lookup
This command displays SNMPv3 group entries.
SYNTAX
security switch snmp group lookup [index]
index - Index to SNMPv3 group table. (Range: 1-64)
DEFAULT SETTING
Displays all entries.
To Next Page
