Digisol DG-GS4528S - Showing Commands

C HAPTER 8 | Using the Command Line Interface
Entering Commands
– 260 –
SHOWING COMMANDS
If you enter a “?” at the command prompt, the system will display the first
level of keywords or command groups. You can also display a list of valid
keywords for a specific command. For example, the command “system ?”
displays a list of possible system commands:
>help
General Commands:
-----------------
Help/?: Get help on a group or a specific command
Up : Move one command level up
Logout: Exit CLI
Command Groups:
---------------
System : System settings and reset options
IP : IP configuration and Ping
Port : Port management
MAC : MAC address table
VLAN : Virtual LAN
PVLAN : Private VLAN
Security : Security management
STP : Spanning Tree Protocol
IGMP : Internet Group Management Protocol snooping
Aggr : Link Aggregation
LACP : Link Aggregation Control Protocol
LLDP : Link Layer Discovery Protocol
LLDPMED : Link Layer Discovery Protocol Media
QoS : Quality of Service
Mirror : Port mirroring
Config : Load/Save of configuration via TFTP
Firmware : Download of firmware via TFTP
UPnP : Universal Plug and Play
MVR : Multicast VLAN Registration
Voice VLAN: Specific VLAN for voice traffic
MLD : Multicast Listener Discovery (Snooping)
Type '<group>' to enter command group, e.g. 'port'.
Type '<group> ?' to get list of group commands, e.g. 'port ?'.
Type '<command> ?' to get help on a command, e.g. 'port mode ?'.
Commands may be abbreviated, e.g. 'po co' instead of 'port
configuration'.
>
The command “system ?” will display the following information:
>system ?
Available Commands:
System Configuration [all] [<port_list>]
System Name [<name>]
System Contact [<contact>]
System Location [<location>]
System Timezone [<offset>]
System Reboot
System Restore Default [keep_ip]
System Load