C
HAPTER
10
| IP Commands
– 273 –
◆ If DHCP is enabled, the system will immediately start broadcasting
service requests. Requests will be broadcast periodically by this device
in an effort to learn its IP address. (BOOTP and DHCP values can
include the IP address, default gateway, and subnet mask). If the
switch does not receive a response from a DHCP server, it will default to
the IP address 192.168.2.10 and subnet mask 255.255.255.0.
◆ If the IP DHCP option is enabled, the switch will start broadcasting
service requests as soon as it is powered on.
EXAMPLE
IP>dhcp enable
IP>dhcp
DHCP Client : Enabled
Active Configuration:
IP Address : 192.168.0.3
IP Mask : 255.255.255.0
IP Router : 0.0.0.0
DNS Server : 0.0.0.0
SNTP Server :
IP>
ip setup This command displays or sets the switch's IPv4 address and gateway for
the specified VLAN.
SYNTAX
ip setup [ip-addr] [network-mask] [gateway] [vlan-id]
ip-addr - IPv4 address.
network-mask - Network mask for the associated IP subnet. This
mask identifies the host address bits used for routing to specific
subnets.
gateway - IP address of the default gateway.
vlan-id - VLAN to which the management address is assigned.
(Range: 1-4095)
DEFAULT SETTING
IP Address: 192.168.2.10
Network Mask: 255.255.255.0
Gateway: none
VLAN: 1
To Next Page
