Digisol DG-GS4528S - Security Switch Snmp Trap Community; Security Switch Snmp Trap Destination; Security Switch Snmp Trap Version

C HAPTER 15 | Security Commands
SNMP Commands
– 332 –
security switch
snmp trap version
This command displays or sets the SNMP trap protocol version.
SYNTAX
security switch snmp trap version [1 | 2c | 3]
1 - SNMP version 1.
2c - SNMP version 2c.
3 - SNMP version 3.
DEFAULT SETTING
SNMP v1
COMMAND USAGE
This command specifies whether to send notifications as SNMP v1, v2c, or
v3 traps.
EXAMPLE
Security/Switch/SNMP/Trap>version 3
Security/Switch/SNMP/Trap>
security switch
snmp trap
community
This command displays or sets the community string for SNMP traps.
SYNTAX
security switch snmp trap community [community]
community - The community access string to use when sending
SNMP trap packets. (Range: 0-255 characters, ASCII characters 33-
126 only)
DEFAULT SETTING
public
EXAMPLE
Security/Switch/SNMP/Trap>community r&d
Security/Switch/SNMP/Trap>
security switch
snmp trap
destination
This command displays or sets the SNMP trap destination's IPv4 address.
SYNTAX
security switch snmp trap destination [ip-address]
ip-address - IPv4 address or alias of the management station to
receive notification messages. An IPv4 address consists of 4
numbers, 0 to 255, separated by periods.