Digisol DG-GS4528S - Security Switch Snmp User Changekey; Security Switch Snmp User Delete

C HAPTER 15 | Security Commands
SNMP Commands
– 341 –
EXAMPLE
Security/Switch/SNMP/User>add 800007e5017f000009 steve sha elephant des
hippopotams
Security/Switch/SNMP/User>
security switch
snmp user delete
This command deletes an SNMPv3 user entry.
SYNTAX
security switch snmp user delete index
index - Index to SNMPv3 user table. (Range: 1-64)
DEFAULT SETTING
None
EXAMPLE
Security/Switch/SNMP/User>lookup
Idx Engine ID User Name Level Auth Priv
--- --------- -------------------------------- -------------- ---- ----
1 Remote william Auth, Priv SHA DES
2 Remote steve Auth, Priv SHA DES
Number of entries: 2
Security/Switch/SNMP/User>delete 2
Security/Switch/SNMP/User>
security switch
snmp user
changekey
This command changes an SNMPv3 user password.
SYNTAX
security switch snmp user changekey engine-id user-name
auth-password [priv-password]
engine-id - The engine identifier for the SNMP agent on the remote
device where the user resides. (Range: 10-64 hex digits, excluding
a string of all 0’s or all F’s)
user-name - The name of user connecting to the SNMP agent.
(Range: 1-32 characters, ASCII characters 33-126 only)
auth-password - A plain text string identifying the authentication
pass phrase. (Range: 1-32 characters for MD5, 8-40 characters for
SHA)
priv-password - A string identifying the privacy pass phrase.
(Range: 8-40 characters, ASCII characters 33-126 only)
DEFAULT SETTING
None