Digisol DG-GS4528S - Security Switch Snmp Group Add; Security Switch Snmp User Lookup

C HAPTER 15 | Security Commands
SNMP Commands
– 342 –
EXAMPLE
Security/Switch/SNMP/User>changekey 800007e5017f000007 william dogtails
cattails
Security/Switch/SNMP/User>
security switch
snmp user lookup
This command displays SNMPv3 user entries.
SYNTAX
security switch snmp user lookup [index]
index - Index to SNMPv3 user table. (Range: 1-64)
DEFAULT SETTING
Displays all entries.
EXAMPLE
Security/Switch/SNMP/User>lookup
Idx Engine ID User Name Level Auth Priv
--- --------- -------------------------------- -------------- ---- ----
1 Remote william Auth, Priv SHA DES
Number of entries: 1
Security/Switch/SNMP/User>
security switch
snmp group add
This command adds an SNMPv3 group entry.
SYNTAX
security switch snmp group add security-model security-name
group-name
security-model - The user security model. (Options: v1, v2c, or the
User-based Security Model – usm)
security-name - The name of user connecting to the SNMP agent.
(Range: 1-32 characters, ASCII characters 33-126 only)
The options available for this parameter depend on the selected
Security Model. For SNMP v1 and v2c, the names configured with
the security switch snmp community add command (page 338) can
be used. For USM (or SNMPv3), the names configured with the local
engine ID with the security switch snmp user add command
(page 340) can be used. To modify an entry for USM, the current
entry must first be deleted.
group-name - The name of the SNMP group. (Range: 1-32
characters, ASCII characters 33-126 only)
DEFAULT SETTING
None